Normally, the temperature of the liquid level sensor measuring medium is between -40~60 °C, if the temperature is slightly higher, the liquid level sensor can be installed with a heat sink, but how to measure the medium above 100 °C? The high-temperature gas collector type liquid level sensor adopts the gas impulse method, which is used to measure high temperature, corrosive liquid, sewage, etc., and the gas in the gas collector cylinder put into the liquid is in contact with the medium, and the pressure is transmitted to the sensor through the air duct, so as to avoid the direct contact between the sensor and the measured medium. The measured medium temperature is between -40~180°C. The probe is IP68 rated. The material of the gas collector and capillary tube is 304 stainless steel, which is corrosion-resistant and has good toughness. The high-temperature cylinder type level sensor also has other notable features: First: the use of diffusion silicon pressure sensitive elements and diaphragm isolation technology Second: stainless steel capillary connection, directly put into the site, easy to install Third: the amplification circuit adopts an integrated chip and supplies power with a wide voltage Fourth: anti-clogging, anti-scaling, high temperature resistance Fifth: lightning protection, interception interference design, strong anti-interference ability Sixth: Wiring reverse and overvoltage protection, current limit protection (current limit output) The high-temperature gas collector type liquid level sensor is suitable for high-temperature corrosive liquid measurement and other occasions, which effectively solves the problem of high-temperature corrosive liquid and sewage level measurement. If you have any questions about product consultation, product customization, agency, technical inquiry, quotation, etc., please contact Xingyi: 400-600-4496!